Mitsubishi HVAC Controller YAML

Generate a ready-to-use ESPHome configuration for echavet's MitsubishiCN105ESPHome component, tailored to your Mitsubishi unit and board.

🛠️ Device Name:

Friendly Name:

For multi-unit setups, give each device a unique name — e.g., bedroom-1 / "Bedroom 1", office / "Office". Updating an existing device? Set Name to the exact name it was already adopted under in ESPHome (the part before .local) and paste this YAML into that device's existing config. A new or different name creates a duplicate device in the ESPHome dashboard and points the OTA upload at the wrong hostname, so the update silently fails to apply. Which board?
M5Stack Atom S3 Lite (ESP32-S3)
M5Stack NanoC6 (ESP32-C6)

🌀 Indoor HVAC Unit Features Which of the following features does your indoor unit support?

Vertical Vanes Up/down airflow direction control via vertical vane position.

Horizontal Vanes Left/right airflow direction control via horizontal vane position.

Swing Mode Continuous vane swing for wider air distribution.

Dual Setpoint Separate heating and cooling temperature targets in Auto mode.

i-See Sensor Mitsubishi's infrared occupancy sensor for directed airflow to detected occupants.

⚙️ Optional Controls Enable any optional controls your unit supports:

Night Mode Reduced fan speed and dimmed display for quiet nighttime operation.

Air Purifier Control the unit's built-in air purifier, if your model is equipped.

Circulator Fan-only circulation mode without heating or cooling.

Airflow Control Fine-grained control over airflow direction beyond standard vane positions.

🌡️ Sensor Options Would you like to use a remote temperature sensor from Home Assistant?
No
Yes Use a Home Assistant temperature sensor instead of the unit's built-in sensor for more accurate room readings.

Sensor entity name in Home Assistant: Enter the full entity ID from Home Assistant

🧪 Advanced Options Enable any optional features below:

Advanced Diagnostics Exposes compressor frequency, runtime hours, power draw, and error codes.

ISU Functions Internal Setup Unit controls — advanced installer settings for system configuration. Use with caution.

Web Server Built-in web UI for browser-based control and monitoring without Home Assistant.

Bluetooth Proxy Use the ESP32 as a Bluetooth proxy for Home Assistant to extend BLE coverage.

Fahrenheit Compatibility: Enable if your unit uses Fahrenheit. "Standard" for most units; "Alt" for units with non-standard F mapping.

Live YAML Preview:

✅ YAML copied!